Column formwork KS Xlife
The high-speed column formwork with a folding mechanism
- formwork is simply folded open and shut, minimising erection and striking times
- wide adjusting range allows many different column cross-sections between 20 and 60 cm to be formed in a 5 cm grid, without having to change system
- achieves immaculate fair-faced concrete quality because the form-facing is screwed-on from the rear, and there are no form-tie points or frame imprints
- high numbers of re-use cycles and fewer changes of form-facing, thanks to the extremely hard-wearing plastic coating
- the improved surface makes it easy to clean, also with a high-pressure washer, and means that fewer areas need repair
- special sheet structure means sheet can also be nailed at low temperatures without splintering
- column formwork units can be repositioned in a single crane cycle without being dismantled, which saves crane time
- up to a formwork height of 3.60 m, the units can be repositioned in the horizontal with no need for a crane, on shifting-wheels
- safe vertical access with the Ladder system XS
- workplace safety on all sides with column-formwork platforms
- practical accessories – such as panel struts, lifting/repositioning devices etc. – make for safe, easy handling of the formwork
References
System
Quick to plumb and align
The positioning aid makes it possible to plumb and align the formwork easily and quickly using a nail-puller.
Clean edges
The frontal triangular ledge is easy to slot into place and ensures tight, clean corners.
Framax Xlife sheet
- very high numbers of re-use cycles possible, thanks to plastic-enhanced surface and special sheet structure
- fewer positive imprints, due to the sheet's great resistance to scratching and vibrator damage
- fewer areas needing repair, as there is no splintering and far less swelling around nail-holes
- easy, fast (intermediate) cleaning, also using high-pressure washer
Utilisation
Craneless repositioning
When shifting wheels are attached, Column formwork KS units with heights of up to 3.60 m can be wheeled and repositioned on the same level. The four Shifting wheels KS per column are easy to clamp onto the formwork and save a great deal of crane time when manually repositioning the units in the horizontal.
Imprint-free concrete finish
The form-ply is screwed-on from the rear, ensuring fair-faced concrete quality that is free of screw-head imprints.
Suitable products
Ladder system XS
Doka Safety Systems
System-based ladderways with integral ladder cages can be attached to Doka wall and column formwork …
Sealings for fair-faced concrete
Doka System Components
Reliably casting concrete surfaces in the desired fair-faced concrete category is quite a challenge,…
