Composite formwork beam I tec 20
The high-performance beam that saves on quantities
![Composite formwork beam I tec 20]()
![Composite formwork beam I tec 20]()
Technical specifications:
Moment (M): 9 kNm
Shear force (Q): 20 kN
Rigidity (E x I): 640 kNm²
Weight: 5.6 kg/lfm
Certificate: Z-9.1-773High load capacity
achieved by innovative composite technology
- permitted bending moment M = 9.0 kNm
- permitted shear force Q = 20.0 kN
- rigidity E x I = 640 kNm²
- weight = 5.6 kg/lin.m
Save on equipment
thanks to optimised load capacity
- up to one-third fewer floor props on timber-beam floor formwork Dokaflex 30 tec
- up to 30 percent fewer form-tie points in wall areas Timberbeam formwork FF100 tec and Top 100 tec
- 50 percent fewer primary beams in the superstructures of fully loaded Load-bearing tower Staxo 40
More repeat uses
thanks to all-round protection
- extra-long lifespan, thanks to the proven 'top' beam-end reinforcement
- reduced close-out costs, thanks to the I tec sheet that protects the whole length of the flanges
(A) Top-beam-end reinforcement
(B) I tec sheet
(C) Beams marked in 50-cm increment-grid
(D) System holes
(E) Notch for chalk lineTimber formwork beam H20 top
Up to triple the lifespan, thanks to built-in shock absorber at the beam end
![Timber formwork beam H20 top]()
- Reduced damage at the end of the beam
- Effective protection against moisture and UV radiation
since ends are sealed around web. - Fast, safe formwork set-up
with markings on the beam chords
(A) Top-beam-end reinforcement
(B) Web in versions N or P
(C) Beams marked in 50-cm increment-grid
(D) 2 system holes at each beam end
(E) Notch for chalk line
(F) Labeling belt width side; Optional: Customising possibleTechnical specifications:
Moment (M): 5 kNm
Shear force (Q): 11 kN
Rigidity (E x J): 450 kNm²
Weight: 4.4 kg/lfm (N) | 5.3 kg/lfm (P)
Certificate: EN 13377Timber formwork beam H20 eco
The tried-and-tested formwork beam with a solid-web design
![Timber formwork beam H20 eco]()
- High-quality beam chords
thanks to mechanical stress-grading - Less damage to beam-ends
owing to bevelled flange-ends and beam rivets - Easy to handle
because of its very low weight
(A) End-reinforcement with bevelled beam-ends and extra plastic rivet
(B) Web in versions N or P
(C) Beams marked in 50-cm increment-grid
(D) 2 system holes at each beam end
(E) Labelling belt width side; Optional: Customising possibleTechnical specifications:
Moment (M): 5 kNm
Shear force (Q): 11 kN
Rigidity (E x J): 450 kNm²
Weight: 4.4 kg/lfm (N) | 5.3 kg/lfm (P)
Certificate: EN 13377
