Load-bearing tower Staxo 40
The lightweight shoring system for the building construction field
- wide-area assembly decks with planking units inside the towers and also between the towers
- horizontal pre-assembly possible thanks to crane-handling-safe connections between the frames
- sturdy ladderways
- tested anchorage points for personal fall arrest systems
- high-speed assembly, as there are only a few separate components, all of them very light in weight
- ergonomically engineered H-frames – easier to carry, quicker to set up
- the ability to travel and lift entire towers, instead of labour-intensively dismantling them first
- colour-coded diagonal crossbraces so that you can quickly tell which length is which
- screw-jack U-heads and feet with a 70 cm extension range for easier height adjustment
- shifting-wheels for relocating entire towers, to facilitate an efficient construction workflow
- safely sustains loads at slab-edges by means of brackets
- ease of handling, logical assembly sequence and high-speed working
References
Zvornik Hydropower Plant – construction of Annex 5 to the dam
Modernization of the production capacity of the Refinery in Pančevo
System
Staxo 40 frames
- ergonomically shaped H-frame geometry with low dead weight for easy handling and short assembly times
- sturdy, galvanised H-frames with heights of 0.90 m, 1.20 m and 1.80 m for easy and cost-efficient height adjustment
- defined anchorage points for personal fall arrest systems (PFAS)
Diagonal crosses
- different lengths for variable inter-frame spacing in 50-cm increments from 1.00 m to 3.00 m
- fixed to the load-bearing tower safely and quickly with innovative safety catches
- clear identification of lengths through coloured clips and imprint
Built-in system safety
- ladder system with non-skid rungs available for any combination of frames
- anchorage point for personal protective equipment (PPE) anywhere on the frame's diagonals
Plane decking levels with scaffold planking
for quickly and safely erecting and dismantling the superstructure
Screw-jack heads and feet
- extension lengths of 70 cm (at top and bottom) for a total of 140 cm adjustment to changes of level and to inclinations
- precision adjustment, right down to the last millimetre, even when under load
- three-wing spindle nut makes for easy height adjustment and rapid screw-jack release
- easy to release, using either a formwork hammer or a reinforcement rod
Utilisation
Efficient and safe erection
- its lightweight, ergonomic components make for an effortless set-up without a crane
- can be erected in the upright with scaffold planking units, 'move-up' railings and available add-on ladderways for high workplace safety
- optional assembly in the horizontal for high workplace safety
Tower-to-tower walkway openings
for fast, safe working inside the scaffold and beneath the towerframe superstructure
Safe working at the edge of the floor-slab
by mounting platform brackets to the towerframes
Cantilevering concrete loads transferred safely
by the high load capacity of the platform brackets combined with a plumbing strut
Craneless horizontal repositioning
with clamp-on shifting-wheels – a simple, sturdy solution that can quickly be connected to the tower
Connecting up scaffold tubes
Scaffold tubes can be connected to every frame, using standard couplers
Getting inside the towerframes is made easy
by the geometry of the Staxo 40 frames
